Адаптер позволяет сверлить в трубах диаметром от 80мм до 200мм и под углом от 0 до 50 градусов. Manufactured by our company precision drilling adapter for pipes GS10-02 allows to cut whole or part of hole in the pipes with diameter from 80mm up to 200mm. Wide range of drilled diameters is differentiator of our design. Drilling adapter allows to set up angle with range from 0 to 50 degrees. Settings can be precisely adjusted. For a successful it is recommended to use high quality HSS twist drills and / or economical and made from the best bi-metal MK MORSE hole saws, that we are representing in Poland. As a drive can use a drill with variable speed. Speed adjustment is required especially when drilling in stainless steel pipes (for example - for 40mm diameter made from stainless steel rotation should not be higher than 110 rpm). Parameters: Range of drilling diameters: from 80 to 200mm, Range of angle adjustment: from 0 to 50 degrees (precision scale), Mount: 2-axes with regulation, Bearings: needle roller bearings (sealed) in which rotates hardened shaft with mounted on it hole saw. Installation: intuitive assembly in a workshop vise. Additional adapter can be screwed to the worktable. Hole saws are available with diameters starting from 14mm and above. You can purchase it also from our store. Adapter is allowing also using twist drills for metal with standard cylindrical shank as well as step drills. High quality of twist drills is required to achieve good effect with stainless steel (adapter is supplied with chuck 13mm).